Watson marlow 101u/r manual

This is an indication of the limiting control and speed levels of the drive. Reset to operate within these levels. If the front panel s witch is to be us ed for changing between "manual" and "auto", link pins 6 and 13 in the 15pin Dee connector. If a remote switch is to be used, ensure that no link is present between pins 6 and 13, and w ire the s witch between pins 7 and 13 of the pin Dee connector. Close switch for auto-control.

Connect r emote s witch betw een pins 8 and 13 of the 15 pin c onnector. Low input stops the pump, high input runs the pump. With no connection, the pump will default. Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox.

Please check your email for further instructions. Enter a new password. Two year warranty Watson-Marlow Lim ited awrrants, s ubject to the conditions below, through either Watson-Marlowted, Limitsi subsidiaries, or its authorised distributors, to repair or replace free of charge, including labour, any part of this product which fails within two years of deliver y of the pr oduct to the end user.

Suc h f ailure m ust have oc curred bec ause of defect in material or workmanship and not as a result of oper ation of the pr oduct other than inordanceac with the instructions given in this manual. Information for returning pumps Equipment which has been contaminated w ith, or exposed to, bodyfluids, toxic chemicals or any other substance hazardous to health must be decontaminated before it is returned to Watson-Marlow or its distributor.

Safety In the interests of safety, this pump and the tubing selected should only be used by competent, suitably trained personnel after they have read and understood this manual, and considered any hazard involved. Recommended operating procedures DO keep delivery and suction lines as short as possible using a minimum number of swept bends.

DO keep the track and rollers clean. Troubleshooting Should the pump fail to operate, make the following checks to determine whether or not servicing is required.

The pump will provide an increasing flow rate for rising control signal non - inverted response or an inc reasing flow rate for falling control signal inverted response. Remote auto manual switch and TTL option If the front panel s witch is to be us ed for changing between "manual" and "auto", link pins 6 and 13 in the 15pin Dee connector.

With no connection, the pump will default to running. You can only view or download manuals with. Here is an attached link to the pump pin diagram. Find great deals on eBay for watson marlow pump and watson marlow peristaltic pump. Shop with confidence. Inloggen; Categorie. Manufactures Specifications. Voltage: to , V. Find great deals on eBay for watson marlow r pump. Skip to main content. Shop by category. Watson Marlow U. Free Shipping.

Specification Flow rate ranges per channel 0. The pumps are reversible and are fitted with the type RL pump head which accepts tubing up to 8mm internal diameter. The pumps have bright green LED readout and membrane keypad which is lockable for secure operation; microprocessor control with DC servo motors provide instantly reversible flow, rapid priming and an auto-restart facility allows the pumps to be controlled by a timer or to recover automatically from mains failure.

The pumps accept tubing from 0 5 mm to 8 0 mm bore; clockwise pumphead rotation gives extended tube life and anticlockwise rotation gives greater pressure. Cassettes accept standard manifold pump tubing Each cassette may be removed during operation without disturbing the pumplng action of any other. The pump has a green backlit LCD readout and membrane keypad which is lockable for secure operation; microprocessor control with DC servo motors provide instantly reversible flow, rapid priming and an auto-restart facility allows the pumps to be controlled by a timer or to recover automatically from mains failure.

The display may be chosen to show either rpm or flow rates by setting either the pumphead and tube size or by running a calibration dose.